How to apply Dalapro Roll Nova

To start, check the surface. You should also sand and fix any holes or rough spots. 

Use a roller on a pole to apply the Dalapro Roll Nova to clean, dry, and intact surfaces. Apply the product to as large an area as you think you will be able to smooth before the product starts to dry. The wall covering should be smoothed as soon as it is fully applied to the wall or ceiling area. For best results ensure the minimum temperature is +5°C.

If it has dried too much, open the wall covering once more, and using the roller, lightly go over the drying area.

Use the product on the putty knife when smoothing to apply finely in corners and ceiling angles.

Last but by no means least, skim off the excess product and once dry, make sure to sand it down with 150-180 grit sandpaper. The smooth consistency makes this wall covering easy to apply with a swift eight-hour drying time, which can be achieved with adequate air flow (open windows). Once you are satisfied with the smoothness and appearance, you can prime and paint the surface to finish the project. Drying times can vary depending on temperature and humidity, but it typically takes several hours. Follow the manufacturer's recommendations for drying time.

Remember to follow the manufacturer’s instructions and don’t forget to always wear appropriate safety gear and work in a well-ventilated area when using this product.